Another Benefit of Brake Interlock Systems

Brad Barker
Posted on August 12, 2019

File photo courtesy IC Bus.
File photo courtesy IC Bus.
I recently attended a training session sponsored by a local SWAT team that demonstrated the process of defusing a hostage situation on a school bus. The SWAT team leaders explained that what we were going to experience would be the last effort to resolve the issue and that prior to this, other means of defusing the situation would have taken place first.

We were instructed to cover our ears, and then a “flash-bang” device was set off to distract the perpetrator as SWAT team members stormed the bus. Weapons drawn, they entered the bus yelling for everyone to get down.

One officer came down the aisle while another armed officer jumped into the driver’s seat facing backwards on his knees. This officer, while kneeling in the driver’s seat, accidentally pushed the parking brake valve in with his foot, causing our bus to roll backwards down a short incline. The bus bumped into another bus parked behind it, causing only minor damage to both vehicles and fortunately no injuries to anyone, except to the pride of the responsible officer. It was at this time that I thought that if this bus had been equipped with a brake interlock system, this would never have happened.

So, what is a brake interlock system? It’s a safety system, available from all school bus OEMs, that requires the driver to take a series of steps before the parking brake can be released. The purpose is to prevent unwanted movement of a bus.

One of the simplest forms of this system requires the ignition switch to be on and the service brake to be applied prior to parking brake valve release. Trying to release the parking brake prior to performing these two steps does not release the brakes. A variety of parking brake interlocks have been available for more than 15 years. If you have special-needs buses that are equipped with wheelchair lifts, you may have another form of a brake interlock system.

Requiring the driver to turn the ignition key on and apply the service brake beforehand improves safety, and in the case of a hijacking or hostage situation, is a good way to prevent the assailant from commandeering the bus. It could easily allow a driver being held at gunpoint the means to prevent the bus from moving by purposely not following the required release steps and claiming mechanical problems to the assailant, thus giving law enforcement more time to respond.

All buses can be ordered with variations of this system. I recommend standardizing as much as possible so all release steps are the same between like models of buses.

Brad Barker is a veteran shop manager and technician.
Brad Barker is a veteran shop manager and technician.

Various designs are available at differing levels of complexity. In some variations, the electric control solenoid prevents air from flowing unless the proper steps are followed. The normally closed valve is an air valve with attaching air lines. Some prevent the transmission from shifting out of neutral if a door is open. This system can be ordered on new buses or for retrofitting if desired. IC bus offers a conversion manual for some model years. Bus-specific information is available from local dealerships. The cost to convert depends on how complex you want the system to be.

Language in the National Congress of School Transportation’s National School Transportation Specifications and Procedures has changed little regarding the need for a parking brake interlock. In 2005, the use of the word “may” is used to define the need. In 2010, no change occurred. In 2015, updates were made to say “all buses shall have,” which requires the service brake to be applied prior to release. Where it will stand for the 2020 manual, I’m not sure. The system is a reliable safety feature that could prevent dangerous incidents from occurring.

Brad Barker has more than 40 years of experience in school bus maintenance as a shop manager and technician. He has written numerous articles for SBF. He can be reached at [email protected].

Related Topics: brakes, parts

Comments ( 0 )
More Stories
Video

School Bus Songs: ‘Stop When the Arm is Out’

Michigan City (Ind.) Area Schools’ transportation department, also known as the “stop-arm singers,” recreate The Supremes’ famous “Stop in the Name of Love” — urging motorists to think twice before illegally passing a stopped school bus.

Heidi King’s last day as acting administrator of the National Highway Traffic Safety Administration will be Aug. 31. Photo courtesy NHTSA
News

NHTSA Acting Administrator to Step Down

Heidi King’s last day as acting administrator of the regulatory agency will be Aug. 31. She will be replaced by James Owens, the U.S. DOT’s deputy general counsel.

Be the First to Know

Get the latest news and most popular articles from SBF delivered straight to your inbox. Stay on top of the school bus industry and don't miss a thing!