is it a emission engine? if so it all can be programmed out if it is an egr engine same story with out proper programming it will always be in a derate with a cel on there might be resistor cheats out there for your engine to eliminate certain things
OEM trained in wiring and all engine platforms for over 20 years
what sensors are you trying to remove ones just for garbage truck application if so some programming would have to be changed it would have second throttle and stuff like that programmed into it
OEM trained in wiring and all engine platforms for over 20 years
I’m not sure to be honest. I have the wiring harness removed from the truck. I haven’t installed the motor into the crane yet. Just trying to get my ducks in a row. I was trying to find someone that understands this crap. I’m a old mechanical type guy. The company I used to work for done this same thing, the motor will work physically, just needed someone to figure out the electronics.
I’m not sure to be honest. I have the wiring harness removed from the truck. I haven’t installed the motor into the crane yet. Just trying to get my ducks in a row. I was trying to find someone that understands this crap. I’m a old mechanical type guy. The company I used to work for done this same thing, the motor will work physically, just needed someone to figure out the electronics.