i have a 2013 c2 with allison 1000/2000 series trans it broke down driver said it stopped moving engine running but not moving no lights on dash got it towed in and of course everything was fine it ran it drove fine but it did have to trans codes a 880 tcm lost power and a 604 lost data from trans computer i checked both tcm fuses they where good check power at ecm that was fine cleared codes they did not come back i wiggled all wiring no codes anyone come accross this intermitten code? i cleared the codes and now i got a 614
Edited by - dsalinas1939 on 08/27/2018 06:37:09 AM
the 614 probelm i believe is my real problem i gone down the tree list and i am at a point where its askin me about LRTP validation and it shows that ecm doesnt support LRTP i guess my question would be i am probably looking AT A TCM software problem or an ecm software problem right?
had allison road guy come over and he said code 614 is almost always a bad tcm or tcm needs calibration in our case it was a bad ecm so now the bus runs and drives fine but the speedo dont work uggggg i see out put from trans but no show speed on the cummins data stream