i have a 2012 thomasc2 bus with the little green maintance light flashing i went threw everything ont the dash screen to try and reset the light does anyone no how to turn it out
Edited by - dsalinas1939 on 11/25/2014 04:34:31 AM
no, I have a guide that has the sequence that you move the gearshift in out out of reverse to neutral to drive...I'll post it Monday when i go back to work.
I was formally Baptistbusman. However, I lost my password, and had not updated my email address.
How many miles are on this bus? I’ve found that with my C2’s the green wrench flashes around 30-40K when the filter life reaches 0%. This can be reset using the “shifter” method, but when you start approaching the 60K mark the light starts flashing again when the fluid life reaches 0% and this requires the laptop software to reset the fluid and filter life.
Here’s the steps to reset the filter monitor: Turn key to run position, do not start bus. Shift from Neutral to Reverse Back to Neutral to Reverse Back to Neutral to Drive Back to Neutral Turn Key to off position Wait a moment and start up bus. Check Trans light should go out.
this bus has 65000 on it i changed the fluid and filter and reset all maintance lights with the allison doc didnt no therfe was another way to reset light thanks for the info guys