| Author |
 Topic  |
|
|
Mike B
New Member
2 Posts |
 Posted - 07/19/2010 : 07:42:29 AM
|
| I need a wiring schematic for the turn signals on the old bus. Installing new turnsignal switch don't have any idea where the red wire goes. |
|
|
jwreaume
Active Member
43 Posts |
Posted - 07/19/2010 : 09:21:59 AM
|
| The red wire goes nowhere, if I recall properly. Send me your email address, as I have a PDF of one for a 1993. Likely the same. |
17 years in the truck & bus world, 10 years at an IH Dealer, ASE Certified Master Medium & Heavy Truck Technician and Advanced Level Diesel Engine Diagnostic Specialist, IH Diamond Certified 5 Times, Instructor of Apprentice Techs in Engines, Fuels, Electrical & Electronics.
Ask anything, I likely will have the answer, or at least a believable lie for ya...
120 Units, 5 Bays, 5 Techs, Living the dream baby... |
 |
|
|
matts4290
Advanced Member
224 Posts |
Posted - 07/19/2010 : 4:14:18 PM
|
I have had luck before if you just e-mail bluebird, and they will send you the schematic.
I have a 90, and I know that the flasher in the power box beside the drive has a hot wire going to it, and from the flasher goes straght to the turn signal switch, so whatever power going to the switch is a flashing positive feed. I would imagine any other wires going out would go directly to the turn signals.
|
We can't all be conventional!
http://www.youtube.com/user/matts4290 |
|
|
|
Mike B
New Member
2 Posts |
Posted - 07/20/2010 : 05:54:05 AM
|
| mbatchelor@havc.k12.al.us |
|
|
| |
Topic |
|
|
|
1990 tc 2000
