I have an 08 IC bus with the Maxforce 466 engine . The sensor in the converter is stripped out and part of the sensor is in the bung .I have read where some have rethreaded or even wielded in a new bung . If so where did you and what size was the bung ? I know it would cost a small fortune to replace the converter . So What is the best step here ? Thanks
i am assuming u are talking about the temp sensor i have drilled them out and retapped the hole done it a few times with good results the thread pitch is 12x1.25 gotta use a flat bottom tap so it goes down far enough
Edited by - dsalinas1939 on 03/18/2020 12:48:58 PM
Yea I do these all the time , most of the time I heat up and remove and use a flat bottom tap like dsalinas was saying , got one under 10$ on amazon , or I just cut out the old bung with a cutting wheel and weld in a new one . the new bung kit comes with a large enough square plate that covers the area where the old one was removed and the bung fits on top . if I cant remove the old egt sensor I cut out and weld if it can be removed I retap the hole