hi guys i am having an intermitten entrance door not closing i have posted about this bus before but its been soooooo intermitten i can never figure itout now its been sittin foe 4 months and now it doesnt close at all there is no signal at the relay to activate the relay i had all the diagrams but can find where i put them old age is killin my brain but any ideas as i try and find my diagrams
yeah its not that i swapped that i been havingthis problem for a long time but so intermitten it was hard to figure out but now it never closes i swapped switch motor relays all the micro switches
i am pretty sure i no what the problem is wire 490y tan and white is grounded some where but i can get the diagram for the dor i no it comes of switch hub module from connector p1-n but i dont no where it goes it disappears in the body and i went to dtna to get diagrams and it says they are not for release to public wtf so does anyone have a door close circuit diagram
i wish i new how to post pictures to show how rediculous the wire routing is and how the rivots holding the window cut the wire and the harness is just hanging in ther so as the bus stops and goes the harness moves causeing that very intermittent problem but its all loomed up now
pics would be a nice feature to figure out , also remember that window exits issues pull the window frame and the wires can be pinched right there ( makes ground on bumps and sets alarm off) C2 buses
OEM trained in wiring and all engine platforms for over 20 years