AUSTIN, Texas — Girardin Minibus is making a strong push to grow its presence in the dual rear-wheel Type A market.

Chief among its strategies is the introduction of the G5, which was unveiled at the National Association for Pupil Transportation’s trade show in Austin on Nov. 1.

Minutes before the opening of the trade show, Girardin President Steve Girardin made a presentation to the bus manufacturer’s dealers and other industry representatives, expounding on the G5’s advanced design and engineering.

Girardin said the G5, which is slated to begin production in January 2006, maintains the company’s trademark design flair with a clean, stylish appearance but also embraces a number of engineering enhancements, including the following:


  • Rubber mounting pucks


  • Modular subframe


  • Modular floor assembly


  • Reinforced side barriers


  • New shape that maximizes floor space


  • Greater interior headroom, floor width


  • Full-length structural beams


  • Straight-mounted front, rear structure


  • Ceiling-mounted speakers that are away from the driver’s compartment


  • Lowered body skirts


  • Extended rear bumper


  • Revised entrance door


  • One-piece roof panel


  • Sealed windows, not gasketed


  • Recessed lights to prevent breakage


    Girardin said the G5 was designed with the input of a multidisciplinary team that identified the needs and wants of distributors and operators. Key priorities of end users were capacity, visibility, headroom, ergonomics, standardization, accessibility, functionality and market acceptance.

    The G5, which stands for “fifth generation,” can accommodate up to 30 passengers but offers floor plans for a variety of applications. It features a redesigned wheelchair lift door that is both wider and taller than its predecessor.

    It also has a one-piece roof panel to reduce water incursion. In addition, the 32-inch, positively locking electric service door is sealed at the bottom to prevent infiltration of water and other elements.

    Mounting the body using rubber pucks improves passenger comfort by absorbing road energy and eliminates the need for periodic tightening of body bolts. “This should save a significant amount of maintenance time,” Girardin said.

    The body, which can be built on a Ford or GM chassis, has an overall width of 96 inches and a 76-inch interior height at the center line. Girardin said the increased interior height and floor width improve mobility and convenience for end users.

    Visibility of the loading zone is enhanced by a fully glassed entrance door and an improved “more-view” window. “This is a significant increase in viewing area,” Girardin said.

    Safety at the rear and sides of the bus is also improved with reinforced side-impact barriers and an 8-inch safety zone that’s been incorporated into the rear wall.