School Bus Fleet Magazine Forums
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Professional Garage
 Enter Forum: Professional Garage
 Rear main seal on Maxxforce
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Trailboss
Senior Member

United States
196 Posts

Posted - 08/15/2016 :  07:35:33 AM  Show Profile  Reply with Quote
2008 IC CE bus with a Maxxforce 7 engine. Oil is dripping out of the bell housing. I'm assuming that the rear main seal is the only thing in the housing that could be leaking. Does it take a special driver to reinstall the new seal.Is there anything special about removing the housing and transmission to replace the seal.
Thanks for any information.

RonF
Top Member

867 Posts

Posted - 08/15/2016 :  1:30:24 PM  Show Profile  Reply with Quote
The manual says to use a seal/wear sleeve installer, IC part number ZTSE4515C.


US Army retired CMBT
Go to Top of Page

Mountain Dew
New Member

4 Posts

Posted - 08/16/2016 :  12:57:41 PM  Show Profile  Visit Mountain Dew's Homepage  Reply with Quote
The last one I did not require any special tools. The new seal came in an aluminum housing, just unbolt the old one and bolt on the new.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
 


School Bus Fleet Magazine Forums © 2022 School Bus Fleet Magazine Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000