Author |
Topic |
|
aaronwilmoth80911
Top Member
538 Posts |
Posted - 08/19/2015 : 09:34:46 AM
|
I've got a 2005 Vision with no audible alarm in the dash at all. It does not sound at all when the bus ignition is cycled to the on position, does not sound with turn signals, and has no audible alarm on the low air pressure, low air light does come on though. Gonna try swapping master gauge and slave gauge from another bus, but if anyone else has any ideas, I'd love to hear them. Thanks. |
|
krmvcs
Advanced Member
362 Posts |
Posted - 08/19/2015 : 10:17:34 AM
|
ive had drivers unplug alarms during their pretrips because they dont want to hear them. trouble is they often forget to plug them back in. im thinking about installing some kind of light taser device under the dash and in the side electrical panel to keep their handd out of there. |
-Ken- |
|
|
Thomasbus24
Administrator
USA
4544 Posts |
Posted - 08/19/2015 : 10:25:22 AM
|
2005...was that the Actia gauge era for the Vision? If so, the speaker on the back of the speedo/master gauge is blown. Somebody here once mentioned digging the speaker out and and installing a replacement. I usually just buy a new speedo head and am done with it. |
|
|
Thomasbus24
Administrator
USA
4544 Posts |
|
aaronwilmoth80911
Top Member
538 Posts |
Posted - 08/19/2015 : 1:13:06 PM
|
Thomasbus24 hit the nail on the head. Swapped gauges from another bus and things are good. Swapped gauge in question into other bus, problem followed. New gauge is on the way. Thanks for the input. |
|
|
Thomasbus24
Administrator
USA
4544 Posts |
Posted - 08/19/2015 : 1:28:52 PM
|
Lucky you. I seem to lose one a year.
At least they got somewhat smart and made it a remot, replaceable speaker after a few years. |
|
|
aaronwilmoth80911
Top Member
538 Posts |
Posted - 08/20/2015 : 1:46:50 PM
|
$550 later, and back to normal again. If there is such a thing as normal.... |
|
|
Thomasbus24
Administrator
USA
4544 Posts |
Posted - 08/20/2015 : 1:48:03 PM
|
But hey, you can roll back the odometer about 100,000 miles when you set the new master gauge! **Wonders how often that happens** |
|
|
aaronwilmoth80911
Top Member
538 Posts |
Posted - 08/24/2015 : 1:48:17 PM
|
New question: I replaced the master gauge, and now my ABS light is staying on. Bendix software shows no codes, Vision manual is stating the the ABS ECU is not communicating with the engine ECM. Any ideas?? |
|
|
r300
New Member
3 Posts |
Posted - 08/25/2015 : 06:25:08 AM
|
Your going to have to reprogram new one through the menu screen |
|
|
aaronwilmoth80911
Top Member
538 Posts |
Posted - 08/25/2015 : 09:44:21 AM
|
The only programming it let me do was the odometer. I have been through every other option on the menu and there is no option for doing this, unless I'm missing something somewhere. |
|
|
|
Topic |
|