Author |
Topic |
|
valleybusman
Top Member
USA
804 Posts |
Posted - 10/16/2014 : 8:40:32 PM
|
I have bus with a DT 466 It's an 2005 model in a IC bus fe 300 . One morning the driver went to start the bus and it started rough . A few days after that it refused to start .So I used my OTC Genesis 3.0 and a whole bunch of codes came up . Hope to get some info re: Code : 4 , 21 , 27 , 100 , 146 , 164 , 244 . Another note tach didn't move and the oil gauge went to 50 psi . I thought maybe my scanner wasn't right but there is no black button . |
|
57fan
Senior Member
United States
148 Posts |
Posted - 10/16/2014 : 9:32:49 PM
|
Never seen them codes from a IC engine. How did you connect your OTC to the 9 pin connector? IC codes are usually 3 digit. First thing to do is turn on the key to run and listen to the turbo 'Cycling" then turn it to off you should hear the turbo "bounce" verifying that the ECM is getting power. If not you have a power issue. fist place I always check is the ECM power relay and IDM power relay. On the FE they are located behind the drivers side wiper door. Be sure to check the fuses and connections in the battery box. Only had one fuse ever blow in the box and it was an IDM meltdown. The ECM sends the oil pressure signal to the MSM module and it interprets the ECM info and send the signal to the oil pressure gauge telling you what the pressure is so you will usually see oil pressure reading and no tach.
|
Lead, Follow or get out of the way! Thomas Paine |
|
|
valleybusman
Top Member
USA
804 Posts |
Posted - 10/17/2014 : 07:26:25 AM
|
Yes I used the 9 pin . I wonder if maybe my programs on Genysis 3.0 are not meant for something this new ? Thanks |
|
|
RonF
Top Member
867 Posts |
Posted - 10/17/2014 : 10:32:07 AM
|
I have to agree with Valleybusman, I have never seen those either. We use MaxxForce software. |
US Army retired CMBT |
|
|
mhernandez73
Senior Member
124 Posts |
Posted - 10/27/2014 : 04:32:04 AM
|
you can toggle cruise and resume buttons to get codes |
|
|
valleybusman
Top Member
USA
804 Posts |
Posted - 10/29/2014 : 8:28:43 PM
|
I have heard that . How do you toggle the switches ? |
|
|
Thomasbus24
Administrator
USA
4546 Posts |
Posted - 10/30/2014 : 04:04:24 AM
|
Assuming you have cruise on the wheel, I believe it's:
Start bus Push left switch up and right switch down at same time
It could be reverse...it's been awhile. |
|
|
Fastback
Top Member
1500 Posts |
Posted - 10/30/2014 : 04:59:54 AM
|
An FE would not have steering wheel switches. Likely will be a diagnostic button under the dash like the 2001 and earlier 3800 conventionals that used the same instrument cluster as your 2005 FE. |
Why yes, the ORIGinal CHARGER is a Fastback |
Edited by - Fastback on 10/30/2014 05:02:01 AM |
|
|
Thomasbus24
Administrator
USA
4546 Posts |
Posted - 10/30/2014 : 08:47:59 AM
|
Oops...I missed the FE!!!!! Sorry. |
|
|
|
Topic |
|