| Author |
 Topic  |
|
|
robert21
Active Member
United States
10 Posts |
 Posted - 06/12/2010 : 09:09:07 AM
|
Hello fellow "enthusiasts",
we have this 2005 International 4300 with "check A/C" warning light lit on the dash. We checked system pressures, they were low, due to leaking thermistors; we replaced both thermistors and recharged the system, the light is still on, the system does not cool, _ no power to compressor clutch, thermistors or the high pressure switch. We do not have a scanner for this truck. Does anyone know how to turn off the "check a/c" light? do we need a scanner?
Thanks for your time.
Bob C |
|
|
robert21
Active Member
United States
10 Posts |
Posted - 06/12/2010 : 10:37:45 AM
|
| We found that by disconnecting the battery for a while, making sure the capacitors were drained of residual current; then reconnecting battery- now it works like a champ! |
 |
|
|
jwreaume
Active Member
43 Posts |
Posted - 06/14/2010 : 08:43:38 AM
|
You can try the following to clear the codes from the Body Controller or ESC:
Key On
While the gauges are cycling, put on the left turn signal, and press and hold the Cruise ON and Cruise SET buttons for about 5 seconds.
This will clear the codes in the ESC/BC. |
17 years in the truck & bus world, 10 years at an IH Dealer, ASE Certified Master Medium & Heavy Truck Technician and Advanced Level Diesel Engine Diagnostic Specialist, IH Diamond Certified 5 Times, Instructor of Apprentice Techs in Engines, Fuels, Electrical & Electronics.
Ask anything, I likely will have the answer, or at least a believable lie for ya...
120 Units, 5 Bays, 5 Techs, Living the dream baby... |
Edited by - jwreaume on 06/14/2010 08:44:06 AM |
|
|
|
edwright
New Member
1 Posts |
Posted - 06/10/2013 : 12:17:16 PM
|
| I wanted to give you guys a great big thank you. I have a 2005 8600 . I found your page by Googling 2005 International 8600 a/c pressure switch. My truck was low on coolant. I recharged it but the air conditioner still did not work. I tried the reset procedure mentioned on this page and voila I had ice cold a/c again. THANKS!!! |
|
|
|
B0b
Active Member
29 Posts |
Posted - 08/30/2018 : 4:13:09 PM
|
| I know this is real old but so am I. Im having seemingly the same problems but mine trips off after a few minutes run time after resetting. 613 code points to the A / C controller but thats not the problem. Works good when it works but it keeps tripping off. Pressures are good. |
|
|
| |
Topic |
|
2005 International 4300 - A/C n/w
