i have code 3563 and i am trying to locate the def heater relay to do some testing but cant figure out where it is does anyone no where that relay is located
ok i found the relay i only have 4 volts to the relay now the diagram says there are three line heater relays but i only see one i have power to the fuse i have power coming out of fuse but the wire coming from the fuse goes back into the big harness and not right to the relay does anyone no where it goes before i start riping the harness apart
you have the three pdms(fuse boxes) on driver side fender , the harness from frame to these usually find one power wire that turns into 4 or 5 wires that feed these pdms, shouldn't be in the ATD harness due to the fact of the voltage to your relay being low
OEM trained in wiring and all engine platforms for over 20 years
yes its a 2013 with the three fuse boxes i opened up the three big harnesses coming from the fuse boxes and right where it y's off there is a splices with three wires they where badly corroded cut it out resoldered and shrink wrapped cleared codes test drive good to go thanks guys
I just had one pull in this morning with the same issue. Ended up finding a broken wire in the loom right below the third fuse block. That harness had rubbed the inside edge of the fiberglass fender. This is when a pic would be useful
yeah minw was water issue with corrotion i would have put pictures of location it was rigth near the shock where the harness y's off but i dont no how to post pictures here