i am tryin to get the crank pulley off a 2010 ic dt466 i have done this on older ones but just wanna make sure after i take the three bolts out that plate should come out and then there is a spot for puller behind it is this correct cause i cant get that little plate out
Edited by - dsalinas1939 on 10/06/2016 11:52:14 AM
Correct, it is the same as the older units, Remove the 3 bolts then use a puller to pull it off. As for removing the plate, i tap it with a hammer and use the bolts to grip the holes, turn it back and forth while pulling it should pop out.
ok thank u i got it i thought i was the same but i never had a hard time getting that plate out on a hole other topic are head bolts on a 466 reusable or should u replace them????
ok i got a young guy for the job lol what do u guys use to put the cam gear on the camshaft basically i have a dt that broke a lifter keeper and killed the cam i hava a puller to get gear off just not sure how i am gonna put it back on yet