I am working on a 09 C2. The wipers will work no problem on high, but have a problem on low, they will just stop after a while, but they will stay on on high.
I have found fuses and relays that say "wiper high" on them, but none for "wiper low."
Is there a wiper delay module somewhere? Anyone else had problems like this?
Here is some info from Thomas: check resistance across pin 1 and 6 of the wiper t/s switch connector for wipers. pin 6 wiper off R1 24 wiper intermittent R2 56 wiper intermittent R3 100 wiper intermittent R4 160 wiper intermittent R5 240 wiper intermittent R6 390 wiper low speed R7 680 wiper high speed R8 1600 Think of the wiper switch as 8 smart switches in one unit and hands off info to the icu dash unit and then sends it to the bulkhead module which gets it's power from the PDM on the lt. fender. So you would check those fuses as well.