School Bus Fleet Magazine Forums
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Professional Garage
 Enter Forum: Professional Garage
 C2 - No power to activate xing arm
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

1983ChevroletWayne
Senior Member

Canada
173 Posts

Posted - 02/13/2014 :  5:29:43 PM  Show Profile  Reply with Quote
Hey guys,

2011 C2 will not activate the power to the air crossing arm when red lights are flashing. Stop arm works fine. When the connector to the stop arm is plugged into the connector (under the control panel) for the crossing gate it works and the stop arm stays in. Fuses check out good in the control panel.

Anyone ever have this one? There must be a bad wire hiding someplace.

Any tips I can pass along to our mechanics?

1983ChevroletWayne
Senior Member

Canada
173 Posts

Posted - 02/14/2014 :  12:27:49 PM  Show Profile  Reply with Quote
Turned out to be a corroded pigtail connector on the C5 circuit of the CHM (Chassis hub module)

Complete wiring for this and the stop arm system were found on section "48" of the wiring diagrams from freightliner.

Formerly "83ChevroletWayne"



Pic courtesy of: "schoolbusdriver.org"
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
 


School Bus Fleet Magazine Forums © 2022 School Bus Fleet Magazine Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000