Subscribe Today

April 02, 2013  |   Comments (2)   |   Post a comment

Alarm aims to prevent bus rolling incidents

A school district and a bus dealership in Indiana have combined efforts to develop a retrofit for school buses that they say enhances safety. The alarm sounds if a driver unfastens his or her seat belt and has not engaged the air brake parking system.


SHARING TOOLS   | Email Print RSS
Fort Wayne Community Schools and MacAllister Power Systems collaborated on a system that warns drivers if they have unfastened their seat belt without engaging the air brake parking system.

Fort Wayne Community Schools and MacAllister Power Systems collaborated on a system that warns drivers if they have unfastened their seat belt without engaging the air brake parking system.

A school district and a bus dealership in Indiana have combined efforts to develop a retrofit for school buses that they say enhances safety.

Fort Wayne Community Schools, the largest district in Indiana, has encountered numerous situations over the years that have been the result of drivers failing to engage the parking brake on buses with air brake systems when the bus was placed in neutral. When this happens, the bus can roll freely if it is parked on a hill.

The most significant incident in Fort Wayne involved a driver who dropped children off for a field trip and exited the bus, then discovered that the bus was rolling down a hill toward a busy roadway. The driver chased the bus to try to get back on board, but she fell beneath it and was run over by the rear wheels.

Gary Lake, transportation director for Fort Wayne Community Schools, told SBF that the driver in that incident only suffered compression injuries to the leg — no broken bones. But it reinforced the notion that something had to be done to prevent these types of mishaps.

Lake said that he and garage technicians Mike Emerson and Vin Smith have over the last several years tried to encourage manufacturers to come up with a system that warns drivers if the bus is in neutral and the parking brake has not been set.

Last spring, after a less-serious incident occurred, the discussion began again. This time, someone came up with an idea to solve the problem.
Brian Woodring, a product service and support specialist for Indiana Blue Bird dealership MacAllister Power Systems, was in the technicians’ office and overheard the discussion. Woodring had an idea: Put a low pressure switch on the air brake engage button and wire it to a seat belt with a buzzer.

Woodring came back in a few days and had a simple mockup of a system that could be wired to a conventional truck seat belt that had a low-volt buzzer and light that could be seen and heard by a driver. The alarm would sound if a driver unfastened his or her seat belt and had not engaged the air brake parking system.

Lake said that the design was shared with Indiana State Police officers and state Department of Transportation inspectors and was found to not impair with any safety functions of the bus. The concept was then shared with Mike LaRocco, director of the Office of School Transportation at the Indiana Department of Education, who Lake said found it to be a useful safety device and approved it for retrofit installation on school buses.

Fort Wayne Community Schools currently has three buses equipped with the system and is making plans to convert its entire fleet. The cost for conversion parts is $355 per bus.

Lake said that he is encouraging manufacturers to include the alert system on new buses.


Post a Comment

It would be good if the warning buzzer system could be modified so it could also be used on hydraullic brake systems. On our late model IC buses the spring applied and brake fluid pressure released parking brakes have a yellow dash switch that resembles an air-brake system (air brakes are an option on the IC/Navistar buses). If something like this can be set-up for an air applied parking brakes why could it not be done equally as successful for the pressure pump assited hydraullic parking brakes. I like the concept of where it alarms if the driver un-belts and leaves the drivers seat 'without' applying the parking brake first. It a scary feeling having that happen. Once I checked the inside rear of an empty bus and realized it was starting to roll! Thankfully I dashed forward and stopped it without accident or any harm. Wish the companies would invest in this feature versus another fancy and likely more expensive way to ensure a driver goes back to check for sleeping children. Concentrate on the ones they can win.

BeeBopEh    |    Aug 22, 2013 03:25 PM

Our bluebirds have that on 07 to current models

Jason Pierce    |    Jul 31, 2013 11:33 AM

Post a comment





Related Stories

Premium Member

Get bus sales numbers, transportation statistics, bus specifications, industry survey results, bus loading and unloading fatality statistics and more in the School Bus Fleet Research Center. Become a premium member today!
Log in Button Register Button

Newsletter

Get breaking news, industry updates, product announcements and more.